Cirronet SEM2410 Guide de l'utilisateur télécharger pdf (Page 21)

SEM2410

Bridge Settings

This dialog allows the user to set the Mode, (Master or Slave), any Filtering (see the section on Filtering

below) and whether or not a Login is required. Selecting “No” grays out the Username/Access-code,

Password and (Password) Verify fields. Selecting “Yes” allows entries to be entered into the fields.

Details on these settings are provided in the section on Bridge Commands.

Bridge (Connection) Status

This dialog displays statistics related to the connected radios including UserName (if no username is

assigned, N/A will display), IP Address, Radio ID and Packet/Error Information.

Access Control Settings

This dialog allows the setting of login preference, “admin” (default), “enable” or “guest”. Setting “admin”

allows the user rights to change parameters; setting “guest” limits the access to RF Tools only. After

changing the Console setting, click Apply to invoke the changes. Click on Cancel to discard any changes.

Clicking on Enable IP address control and then Apply brings up the dialog below.

Enable IP address Control

This dialog is used to designate the Allowed IP addresses from which the SEM2410 will accept a telnet

session request. Simply enter an IP address in the “Allowed IP address” field and click “Add IP address.

Only IP addresses designated by this dialog can access the device when IP address control is Enabled.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 36 37

Pas de commentaire

Cirronet SEM2410 Guide de l'utilisateur Page 21