Cirronet SEM2410 Guide de l'utilisateur télécharger pdf (Page 7)

SEM2410

Getting Started

The SEM family of wireless Ethernet modems is easy to install and operate. In most instances,

the only installation steps will be setting IP addresses, configuring one SEM as the master and

connecting the antenna, power and Ethernet cable. While the operation of the SEM2410/D and

SEM2410X/DX is the same, the installation and connection is slightly different. Please refer to

the appropriate section below for connection and installation of your product.

Setting up a pair of SEMs requires the following steps:

• Enter IP addresses into each SEM

• Configure one SEM as the Master

The default settings in the SEMs are sufficient to allow connection to Ethernet networks and to

have the slave SEM connect with the master. Other steps you may want to take include:

• Enter a default route IP address if data is to be sent off the SEM’s subnetwork (See

Ethernet Commands)

• Enable one or more of the security features of the SEM (See Security Commands)

• Adjust the RF bandwidth allocation (See Radio Commands)

• Filter out broadcast and multicast packets (See Bridge Commands)

• Change the network number (See Radio Commands)

Instructions on setting up the SEMs are detailed in the Configuring the SEM section of this

manual. Details on the various operating modes and configurations can be found the SEM

Operation section.

1 2 3 4 5 6 7 8 9 10 11 12 ... 36 37

Pas de commentaire

Cirronet SEM2410 Guide de l'utilisateur Page 7